Home > Knowledge > Content
Analysis of the micro tillage machine operation of common sense
- Sep 23, 2017 -

1, micro farming machine operators must be trained or read the machine instructions before operating the machine, not familiar with the operation method of personnel operation is strictly prohibited. 

2, micro farming machine operators should be Caution! Warning signs on the machine, reading the content of signs carefully, and express the other operator. 

3, micro farming machine operators must pay attention to prevent injuries caused by moving parts winding. Check that all exposed rotating parts have been well protected. 

4, micro tillage machine operator fatigue, so as to avoid accidents.

5, every time before work to check the engine and transmission oil is sufficient.

6, before use must check whether the various components and the gearbox, engine bolts loosening and shedding phenomenon. 

7, check the operating member (bit) is flexible and effective.

8, installed the tillage knife, must confirm the symmetry of working face on the front edge, otherwise not normal use. 

9, before the start of the engine must check whether the separation position in the clutch, the gear lever is in neutral position. 

10, to ensure the normal operation of the engine, prolong the service life, the engine must be empty load operation after the launch, is 5 to 10 minutes before working, before starting to work 1 to 2 hours is best not to high speed and heavy load work. If the engine starts running, it should quickly cut off the oil supply or block into the air passage so that the engine will stall immediately.

11, the resistance bar height to be adjusted at any time according to the work, keep the body horizontal position, to prevent excessive tilt due to engine damage, resulting in poor lubrication of engine. 

12, operation process should be forbidden to touch touch all kinds of rotary cutting tools, to avoid injury, and away from the high temperature exhaust pipe burn. 

13, replacing the cutting tool, remove weeds and maintenance inspection, must be made before the engine stops running. 

14, improve the operating speed of the cutter is prohibited in any way. 

15, engine speed, power and other parts in the experimental stage has been adjusted to normal, non random adjustment. 

16, the machine does not have a lighting device in night work is prohibited. 

17, micro farming machine in near field angle, groove, hole, canal operations to low speed. 

18, adding oil should stop and avoid fire. 

19 in the slope area operations should pay attention to machine balance, can work along the slope direction, slope should be less than 25 degrees. 

20, when the machine is running, is prohibited near or touching the rotating parts, so as to avoid accidents. 21 non micro tillage machine hopper.