Home > News > Content
Safe Operation Technology Of Micro Cultivator In Chinese Micro Tillage Machine Manufacturer
- Oct 18, 2017 -

    China saying: "spring has refused to busy, hungry face yellow in autumn." Now it is spring around the busy season, micro farming machine is farmer spring busy season essential equipment, but farmers in the process of using injuries which is not standardized It is often seen., resulting from the operation of farmers. So, what are unsafe operations in use? How to avoid it?

    First, in the operation, we must first read the instructions, in strict accordance with the instructions of the maintenance requirements, then must undergo operation training to work. 

    Two, check the machine before the operation of each connection fastener is fastened, be sure to tighten the bolts (including walking box part, press box part, engine parts, engine support connecting muffler, air filter etc.). 

    Three, the head, body placed in the horizontal position to check whether to add oil, gear oil, can not be added, can not be less; check whether there is oil leakage (oil, diesel, gear oil) phenomenon, you can use. At the same time remember that the fuel tank can not add gasoline, must add 0# diesel. 

    Four, before use should be at the bottom of the air filter and 1cc oil, while drunk do not operate the micro tillage machine, the new machine allowed large load operation, the field transfer should change the tire, especially the slope operation should prevent micro cultivator dumping wounding. 

    Five, start, must be confirmed before and after the left and right, no security, the rear can start, so as not to hurt people. When the engine doesn't start well in winter, the kettle boiling water can be poured into the oil tank or injected into the combustion chamber 0.5 - 1CC oil, which can start normally. 

    Six, in the process of operation, the middle substitution, talk with people, remove the weeds, winding tool holder, do not clutch clutch in the case of hanging, must be sure that the neutral machine does not advance or flameout when carried out. 

    Seven, micro tillage machine installed on the knife rack, do not walk on cement road, stone ground, in the operation should try to avoid collision with big stones and other hard objects, so as not to damage the blade. When the engine or walking box and pressure box are abnormal, the engine should be checked before shutdown, and the work can be done after troubleshooting. 

    Eight, the operator in the operation if back to the threshold of less than 1 meters, the prohibition of the use of reverse. 

    Nine, the new engine in the normal operation of 20 acres of land, the engine must change the oil and gear oil cooler, otherwise cannot discharge residual oil in the body; 80 - 100 after the replacement of second acres; continuous operation 3 - 5 days to clean air filter, 400 - 700 acres of oil pump and nozzle pressure check, check and adjust the valve clearance, if necessary, replace the piston rings, valve and connecting rod. 

   Ten, after the completion of each operation, should pay attention to clear the micro cultivator of the soil, weed, oil and other attachments, and each check fastening bolts fastening, and find the film or other cover, to prevent the sun and rain rust.